COMBICOM
InterBus-Operator
Version 7.1
00.58.01B-K
10/
InterBus Operator
1
General
1.1 Product Description .2 Definitions .3 Technical Data
2
Communication Interface (PCP)
2.1 Communication Relation List .2 Object Directory .3 Error Codes of the PCP-Channel .8

4. 5
Process Data Channel . IO-Mode .10
Error Codes in the IO-Mode Reading a Parameter in the IO-Mode . Writing a Parameter in the IO-Mode (16-Bit Data Length) Writing a Parameter in the IO-Mode (32-Bit Data Length) Write with Synchronization in the IO-Mode .

Diagnostic Interface Operation
6.1 Diagnostic Elements .2 Connector Pin Assignment .3 Installation .
2
InterBus Operator
1 General
The documentation as well as the hardware and software are developments of the Karl E. Brinkmann GmbH. Errors and omissions excepted! The Karl E. Brinkmann GmbH has prepared the documentation, software and hardware to the best of their knowledge, but no guarantee is g...

InterBus Operator
Instruction Manual InterBus-S Operator
Technical Data Part number Operator Part number Instruction Manual Equipment InterBus-S-Interface InterBus-S ID-Code (Module Ident.) InterBus-S Register Width InterBus-S Diagnosis Isolation to Inverter Voltage Supply Current Input
00.F4. - .F4.Z10-K Clip-On Unit in KEB-Operator Housing LOOP-Topology, Terminals Words IN + Words OUT LED Safe Isolation in accordance with VDE ,5V from the Loop Busterminal mA max.
8
InterBus Operator
Table of Contents TECHNICAL DATA TABLE OF CONTENTS SUMMARY CONNECTIONS DIAGNOSIS DATA TRANSMISSION
Format Parameter Addresses Fault Codes Configuration Parameter Examples Reading a Parameter Writing a Parameter Quick Reading of several Parameters Quick Writing of several Parameters Quick Writing of several Parameter Values on the same Address Writing with Synchronization


Summary The InterBus-S Operator is in a clip-on unit and is connected to a IBS-Loop. InterBus-S (IBS)...

COMBICOM F5
INSTRUCTIONS FOR USE | F5 INTERBUS OPERATOR V7.1
Translation of the original manual Document EN
2
© KEB Automation KG
Signal words and symbols
1 Preface
The described hard- and software are developments of the KEB Automation KG. The enclosed documents correspond to conditions valid at printing. Misprint, mistakes and technical changes reserved.
1.1
Signal words and symbols
Certain operations can cause hazards during the installation, operation or thereafter. There are safety informations in the documentation in front of these operations. Security signs are located on the device or machine. A warning contains signal words which are explained in the following table:
DANGER
Dangerous situation, which will cause death or serious injury in case of non-observance of this safety instruction.
WARNING
Dangerous situation, which may cause death or serious injury in case of non-observance of this safety instruction
CAUTION
Dangerous s...