Poition the manual valve detent lever, aligning it with the cross-shaft bore in the case.

/library/BOOKS/CAR/SsangYong/Actyon/ActyonB0105003.pdf\n69
11. Poition the manual valve detent lever, aligning it with
the cross-shaft bore in the case.
12. Push the shaft through the detent lever until it starts
in the detent lever side of the case.
M / T
CLUTCH
Y A
13. Install the detent lever drive pin in the shaft using
cross shaft pin remover/installer (detent lever) -
with the adaptor over the pin.
AXLE
14. Press the pin into the shaft until the tool bottoms.
15. Remove the tool and fit the spring retaining circlip to
the shaft.
ST’NG
Y A
BRAKE
16. Install the new cross shaft seals using cross shaft
seal installer - (1) and cross shaft bullet
- (2).
A / BAG
A / CON
Y A
17. Install the inhibitor switch on the case. Torque the
bolts as per specifications. Press the pin into the
shaft until the tool bottoms using cross shaft pin
installer/remover (inhibitor switch) -.
Installation Notice
Tightening torque ~ Nm ( ~ lb-in)
18. Thoroughly check the terminal wiring loom for
condition and continuity.
Y A
CHANGED BY ION (BTRA) AUTO TRANSMISSION
EFFECTIVE DATE ACTYON SM -.03
AFFECTED VIN